Fire-magic Aurora Stand Alone Combo Grill A830s Manuel d'utilisateur télécharger pdf (Page 12)

CRANK INSTALLATION

Fit the crank handle into the

hole on the front right side of the

face. Aligning it carefully, screw

it into the nut on the frame. After

installation, crank the handle in

and out to raise and lower the

charcoal pan.

INSTALL THE TOOL HOLDER AND

PAPERTOWEL HOLDER

The rectangular mounting bracket for the tool

holder and the paper towel holder come pre-

attached to the sides of the cart.

Unpack the holder portion, squeeze the open

ends together slightly, and install them into the

mounting bracket (see Fig. 12-2). Next, release

the hanger so that the ends extend out through

the holes in the top and bottom of the mounting

bracket (Fig. 12-3, 12-4).

When not in use, the racks may be folded back

against the wall of the grill (Fig. 12-3, 12-4).

LOCATION PREPARATION

Prepare a ﬂ at, level surface capable of supporting

the weight of the stand-alone grill and convenient to

the gas supply if connecting to a gas line.

WHEELS AND CASTERS

To lock a caster press down on the side of the lever

with the word "ON" stamped on it until it stops and

the caster will not turn. To unlock, press down on the

side stamped "OFF."

INSTALLING THE STAND-ALONE UNIT

Fig. 12-1

Fig. 12-2

Fig. 12-4

Fig. 12-3

CONNECT THE GAS SUPPLY

For connecting a propane unit to a portable

propane tank, read the safety warnings and follow

the instructions in the section SAFE USE AND

MAINTENANCE OF PROPANE GAS CYLINDERS.

For household propane or natural gas units:

1. Turn OFF the gas supply at the source. The

quick disconnect hose is pre-installed on the

valve manifold at the manufacturer. Run the

hose through the hole in the bottom rear of the

stand-alone unit, to the gas supply. Connect

the

" NPT socket at the end of the hose to

the gas supply. Use pipe joint compound that is

resistant to all gasses on the male pipe ﬁ tting

and tighten securely. DO NOT use pipe joint

compound to connect the ﬂ are ﬁ ttings.

2. Turn all burner valves to the OFF position. Turn

the gas supply on. Then carefully check all gas

connections for leaks with a brush and soapy

water before lighting. NEVER USE A MATCH

OR OPEN FLAME TO TEST FOR LEAKS.

Fig. 12-5

REV 0 - 1412031405

L-C2-453

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Commentaires sur ces manuels

Pas de commentaire

Fire-magic Aurora Stand Alone Combo Grill A830s Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Grilles Fire-magic Aurora Stand Alone Combo Grill A830s