Fire-magic Deluxe Classic DI Insulating Liner 3200-50 Manuel d'utilisateur télécharger pdf

Robert H. Peterson Co. 14724 East Proctor Avenue, City of Industry, CA 91746

This liner kit contains 6 panels of insulating material which are 2" thick including the spacers.

Bottom 2pcs 11

" x 28

Front & Back 2pcs 11

" x 26

Sides 2pcs 11

" x 19

The cabinet (or rough opening) speciﬁ ed is 23

" x 28

" wide x 14" deep.

Note: This insulating liner will require support for the bottom insulating panels 14" below the countertop

surface.

When properly installed, each panel will be installed with the solid ﬂ at side of the insulation facing

inward towards the unit on all four sides and the bottom of the grill. The bottom pieces will be a

snug ﬁ t from front to back and must be tight together down the center. The front and back panels

should be centered from side to side and the

side panels ﬁ t in between them. Ceramic tile

or other non-combustible countertop material

may be extended to cover the top edge of the

insulating panels, leaving a counter top opening

of 19

" x 24

The insulating panels may be glued or nailed in

position. It is recommended that all cracks be

sealed with high temperature silicone sealer. A

" hole should be drilled in the bottom panel

near the front to allow entry of a

" pipe gas

line as shown in the grill installation instructions.

The top trim panel, which is available for counter

tops not resistant to heat, will hold the insulating

panels in position and cover the upper edges

of the insulation. It should not touch wood or

combustible material, but may be as close as

" gap which can be closed with silicone

sealer. This panel provides a ﬁ rm surface for the

grill cork mounting supports to rest on. The trim

panel may be painted a color of your choice.

Note: When used with propane gas, additional

holes or other venting must be provided in the

bottom insulating panels and in the cabinet or

air space below. Vents in the liner must not be

adjacent to, or in direct line with combustible materials.

Refer to your grill installation instructions for special propane gas venting requirements.

INSTALLATION OF YOUR FIRE MAGIC GRILL

To install and operate your Fire Magic grill, please refer to the installation and operating instructions

and safety precautions enclosed with your grill unit.

Replacement parts may be obtained from your nearest Fire Magic Dealer. For assistance in locating

a dealer, you may contact the factory at the address listed below.

REV 2 0906011024

DELUXE CLASSIC DROP-IN (31

SERIES) INSULATING LINER

MODEL # 3200-50

L-C2-04409

Drop-In Insulating

Liner #3200-50

Front & Back

Sides

Bottom

Cabinet

28 1/2

23 5/8

28 1/4

26 1/4

11 13/16

24 1/4 I.D.

19 1/4

(Optional) Trim Panel #3200-60

28 3/8

23 1/2

Résumé du contenu

Page 1 - MODEL # 3200-50

Robert H. Peterson Co. 14724 East Proctor Avenue, City of Industry, CA 91746This liner kit contains 6 panels of insulating material which are 2"

Commentaires sur ces manuels

Pas de commentaire

Fire-magic Deluxe Classic DI Insulating Liner 3200-50 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Grilles Fire-magic Deluxe Classic DI Insulating Liner 3200-50. Fire Magic Deluxe Classic DI Insulating Liner 3200-50 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Grilles Fire-magic Deluxe Classic DI Insulating Liner 3200-50